Arduino Module Wifi Esp8266 Esp01

Arduino wireless Transciever Module

48.00 EGP (exc. tax)

Availability: In stock

In stock


– These modules include 1MB of flash memory, while the older blue colored ESP-01 module is 512KB
– The ESP8266 Serial/UART to WiFi module is a great way to connect your Arduino or other microcontroller projects to a WiFi network
Create your next internet of things (IOT) project with affordable network connectivity by implementing this module into your design
– The module has the ability to run independent of a host controller
– The eight pin header includes two GPIO pins that allow for direct connection of the module to sensors, peripherals, or host controller
– The ESP8266 has 3.6V tolerant I/Os so you will need a logic level converter to connect it with higher voltage devices such as Arduino
– The ESP8266 requires 3.3V power so you may need a 3.3V voltage regulator to provide the correct voltage, depending on your setup

802.11 b/g/n
Serial/UART baud rate: 115200 bps
Integrated TCP/IP protocol stack
Input power: 3.3V
I/O voltage tolerance: 3.6V Max (see ?Recommended Accessories? below for level converters to connect to higher voltage devices (i.e. Arduino) )
Regular operation current draw: ~70mA
Peak operating current draw: ~300mA
Power down leakage current: <10?A
+19.5dBm output in 802.11b mode
WiFi security modes: WPA, WPA2[embeddoc url=”” download=all viewer=browser”]

Weight 500 g
Dimensions 14.5 cm


There are no reviews yet.

Be the first to review “Arduino Module Wifi Esp8266 Esp01”

Your email address will not be published. Required fields are marked *