Glcd Nokia 5110

SKU: E-INT-005 Category: Tag:

White/Blue 84 * 48 Nokia 5110 LCD Display Screen Module Module for Arduino DIY

115.00 EGP (exc. tax)

Availability: In stock

In stock



1. “LIGHT” linked with GND, the backlight to be lit.
2. Need you to compress the screen and PCB tighter, might got loose after the delivery.
3 Use a 3.3V controller, otherwise the display could be quite vague.

LCD5110 Module:

Power supply voltage:2.7V-3.3V,5V is OK,but part of the screen becomes black when tested
Data interface level:2.7-5V
Backlight power supply voltage:highest 3.3V
Installation diameter:2mm


84 X 48 dot matrix LCD,can show 4 lines of characters
Use serial interface communicate with the master processor,the number of interface signal line reduced
greatly, only 8 signal lines including power and GND.Support different types of MCU,such as the SPI,
MCS51 serial mode 0 of AVR.Transfer rate up to 4Mbps,can full speed write display data without waiting
Can use the conductive glue to connect the module with the printed board,without connecting cable.The
metal hooks on the module can fix the module on the printed board,which is very easy to install and
LCD controller/driver chip has been bound to LCD chip,the volume of LCD is small
Low power supply,the working current in normal situation is lower than 200?A,and has power-down mode.
Controller Philp PCD8544 LCD controller .
input voltage :2.7-3.3v
can be driverd by Arduino/STM32/8051/AVR/PIC and other low power controllers
Compatible with Nokia 3310 LCD driving source code

Weight 500 g


There are no reviews yet.

Be the first to review “Glcd Nokia 5110”

Your email address will not be published. Required fields are marked *